MikroElektronika mikroProg Manual de usuario descargar pdf (Pagina 17)

Page 17

The programming voltage (Vpp) is provided by the programmer

during the programming procedure. Depending on the type of the

microcontroller, the Vpp programming voltage can be up to 13V. After programming is nished it is possible to power up the target

device via mikroProg

™

programmer. While the device is connected

to the programmer set the desired voltage using the slider. Max

supply voltage is determined by the MCU’s power supply voltage

while minimum voltage is 2.7V (max 250mA). When voltage is

set just check “Power board from programmer” check box.

A warning window will appear. If electrical characteristics of the

target device are correct click Yes. Otherwise click No and set

appropriate electrical characteristics of the connected device.

Check box for enabling supply voltage from programmer

Setting supply voltage value from 2.7 to 5V (max 250mA)

Manually read voltages on Vpp and Vcc MCU pins

Check box for enabling automatic voltage monitoring

Current Vpp value (programming voltage)

Current Vcc value (power supply voltage)

Move slider to set required voltage level

Tick “Power board from programmer” box

Click Yes after the electrical characteristics of connected

device are met.

05 06

Voltage options section

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

MikroElektronika mikroProg Manual de usuario Pagina 17